Sun Microsystems X6450 - Manual (Page 39)

Chapter 2 Installing and Configuring the Server Module 29
▼ To Access the System Console Using the ILOM CLI
1. Connect and log in to the ILOM as described in “Connecting to the ILOM” on
page 25 .
The ILOM prompt appears.
2. To power on the system, type the command:
-> start /SYS
Note – You can also power the system on or off using a stylus, as described in
“Routine Power On and Power Off” on page 3 .
3. To start the system console, type:
-> start /SP/console
4. To exit the system console, press Esc-Shift-9.
5. To stop the system, type:
-> stop /SYS
▼ To Access the System Console Using the ILOM Web
Interface
Note – This procedure shows screens from ILOM 2.0. In ILOM 3.0, the procedures
work the same, but the screens might have slight differences.
1. Log on to the web interface as described in “To Connect to the ILOM Web
Interface” on page 25 .
The Versions screen appears.