Sun Microsystems X6450 - Manual (Page 37)

Chapter 2 Installing and Configuring the Server Module 27
Follow these steps to log in to ILOM using the default enabled SSH connection:
1. To log on to the ILOM, type:
$ ssh root@ ipaddress
where ipaddress is the ILOM’s IP address.
2. Type the password when prompted. The default is changeme:
Password: changeme
Note – After you log in to ILOM using the default user name and password, you
should change the the ILOM root account password (changeme). See the Sun
Integrated Lights Out Manager 2.0 User’s Guide or the ILOM 3.0 documentation
collection for details.
3. To log out, type:
-> exit
Configuring the Service Processor’s Network
Settings (Optional)
The CMM ILOM allows you to change the server module network information,
including the IP address, and DHCP settings.
▼ To Configure the Service Processor’s Network
Configuration:
1. Log in to the CMM ILOM .
See the ILOM documentation for your chassis for details.
2. Navigate to /CH/BL n/SP/network.
Where n is 0 through 9 for server modules 0 through 9 respectively.
Note – You can also change these settings using the ILOM 2.0 or ILOM 3.0 instead
of the CMM ILOM. Navigate to /SP/network instead of /CH/BLn/SP/network.
Once there, the commands are identical.
3. Type the following commands: