Sharp MD-MT877 - Manual (Page 13)

DEUTSCH
FRANÇAIS
ESPAÑOL
SVENSKA
ITALIANO
NEDERLANDS
ENGLISH
13
Caution:
● Use the specified battery AD-N55BT only. Do not charge
a battery (nickel-cadmium, alkaline, etc.) other than that
specified.
● Do not remove the outer cover of the re-
chargeable battery. It may cause heat gen-
eration, fire, or explosion.
● Do not dip the battery in water, do not dis-
pose of it in a fire, and do not take it apart.
● If the rechargeable battery terminal is dirty, charging may
not start. In such a case, wipe off the dirt with a dry cloth.
● Do not disassemble the battery.
About Power Source : continued
About the liquid crystal display (LCD)
The condition of the portable MD will be shown on the LCD
when inserting it into the battery charger.
Display Conditions
Scrolling
Charging.
Turns off
The charging is complete.
When the portable MD is not in-
serted correctly to the battery
charger, or
Rechargeable terminal is dirty, it may
not be possible to charge the bat-
tery. (Wipe the terminal by cotton
swab.)
Refreshing.
The unit checks and, if necessary,
discharge the rechargeable battery
to recharge it automatically. (At this
time battery indicator is flashing.)
About charging time
After about 3.5 hours have passed, “ ” will go out.
The battery is charged up to 95% if it is completely
discharged.
Notes:
● Charge the battery within the range of 41 ° F - 95 ° F (5 ° C
- 35 ° C).
● The unit can be left in the charging state after it is com-
pleted.
● If the MiniDisc unit is not to be used for some time,
remove the battery. (The battery drains gradually even
when the power is turned off.)
● Carry the battery in the supplied case.
Power Source
–
Using with the Rechargeable Battery
–