Sharp MD-MT877 - Manual (Page 16)

16
Preparation – Hold Function –
Hold Function
The present operation condition can be kept even if other buttons are accidentally pressed in a place such
as a crowded train.
To cancel the hold mode
Move the HOLD switch away from the safety posi-
tion (the opposite direction of the arrow).
If the hold function is active while the power is
turned off, the power cannot be turned on by mis-
take and the battery will not be drained.
If the battery is inserted or the AC adaptor is connected,
you can set this function even when the power is turned
off.
To cancel the hold mode
Press and hold down the • ■ / –HOLD button for 2 sec-
onds or more while the unit is in the hold mode.
● “HOLD OFF” will be shown.
Hold Release
Press the • ■ / –HOLD button for 2 seconds
or more.
Move the HOLD switch to the safety position
(direction indicated by the arrow).
Orange mark
Remote control unit Main unit
Hold