ScyTek Electronics PRECISION PRO 5500 - Manual (Page 25)

Precision - Page 21
Panic Mode
In the event of an emergency, the transmitter’s remote Panic feature can be used to instantly trigger the
alarm*/panic feature.
To activate the Panic Mode:
1. Press and hold Button 1 for 5 seconds.
· The alarm will sound.
· The parking lights will flash.
· The doors will unlock** allowing access to the vehicle.
2. Press Button 1 or 2 to stop Panic Mode.
* If the ignition is on when the Panic feature is activated, the doors will lock for personal safety.
If not deactivated using Button 1 or 2, the Panic Mode will automatically exit after 30 seconds and the
system will be restored to its previous Armed*/Lock or Disarmed*/Unlocked state.
* Emergency Override
If the transmitter becomes lost or inoperable, the system can still be disarmed using the following
procedure. Before beginning this procedure be sure to have the ignition key ready and know the location
of the override switch.
To Emergency Override the system:
1. Unlock the door using the key.
2. Enter the vehicle.
· The system will trigger and the siren will sound.
3. Turn the ignition switch to the on position.
4. Press and hold the override switch until the alarm turns off (approximetly 10sec)
· The system will disarm.
5. The vehicle will now be able to start.
Anti-Carjacking Protection
For a higher level of personal security, the system is equipped with three programmable Anti-
Carjacking modes. When any Anti-Carjacking mode is triggered, the parking lights will flash twice
to confirm activation. After 90 seconds the siren will begin chirping for 15 seconds as a warning,
prior to entering full alarm mode. During the full alarm mode, the siren will sound, the parking
lights will flash, and the horn will honk for up to five minutes or until the system is reset.
Manual. When selected, pressing Button 4 of one way remote, or page button 4 of the LCD remote, with the
ignition ON will automatically trigger the Anti-Carjacking feature. Press the Button again to reset the Manual
Anti-Carjacking mode.
Passive. When selected, the Anti-Carjacking feature will activate whenever a door is opened while the
ignition is on. Press the Valet switch 1 time to reset the Passive Anti-Carjacking mode.
Full-Time. When selected, the Anti-Carjacking feature will automatically activate each time the ignition is
turned on. Press the Valet switch 1 time while the ignition is on to reset the Passive Anti-Carjacking mode.
Note: The desired Anti-carjacking mode must be programmed during installation.
* Optional Coded Emergency Override
As an extra measure of security, the Precision 5500 Series is equipped with an optional Coded Emergency
Override feature. Once an Emergency Override Code is chosen and programmed during installation, the
system can no longer be disarmed using the standard override procedure.