ScyTek Electronics PRECISION PRO 5500 - Manual (Page 40)

Page 36 - Precision Pro
14. Disarm with Auxiliary 1. When selected, activating the Auxiliary 1 output (usually used to open
the trunk) will disarm the alarm the system.
15. Aux 2 Auto Activate with Arm. When selected, the Auxiliary 2 output will activate when the
system is armed. This feature can be used to roll-up windows, close sunroofs, activate accessories,
etc. (will not activate if Aux 2 is set to “latched”)
16. Auxiliary 3 Output Mode. Selects between Channel 3, Factory Rearm output, or third Ignition
ouput.
17. Start in Valet Mode. Selects whether or not the vehicle can remote start while in the valet mode.
Using button 3 enables Mp Siren Mode.
18. Lock After Start. When selected, the doors will automatically lock after remote starting.
Using button 3 disabled Mp Siren Mode.
19. Lock After Shutdown. When selected, the doors will automatically lock after remote shutdown.
20. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle.
21. Automatic Start Mode. Selects between every two hours or every one hour for the automatic
engine starting feature.
22. Tachless Sense Crank Time. Selecting engine crank time automatically selects the tachless mode
and one of three crank times.
If the normal engine crank time is too short increase the time by selecting one of the two additional
extended crank time options.
Normal -
0.8Sec.
Extended - 1.0Sec.
Super Extended - 1.4Sec.
Tachless Mode. Determines the engine status using an advanced software routine, without requiring
connection to the vehicle’s tachometer. Tachless operation may not be compatible with some vehicles
or in severe temperatures, in which case the tach wire must be connected.
23. Smart Start Temperature Compansation. adjusts crank time to compansate for temerature
variations.
24. Engine Sense Mode. Enable or disable smart sense monitor or if connected select vacuum pump
monitor.
25. RPM Learn/Tach Monitor This dual program branch sets the engine mode for Gas or Diesel, and
learns the vehicle’s RPM threshold. For installation into a diesel equipped vehicle, first set the engine
type to diesel before learning RPM.
RPM Learn/Tach Monitor. start the engine, enter Branch 21, the LED light will flash continuasly to
indicate it is reading the tach signal. Press Button 1 to learn the vehicle’s tach signal. The siren will
chirp and the LED will flash once to confirm learning of the tach signal. The siren will chirp four
times and the LED will flash four times if the tach signal was not learned.
Tach Monitor mode: monitors the vehicle’s tach wire (or a fuel injection wire) in real-time to
determine engine status and adjust starter crank time automatically.
Gas Engine. Sets the engine type for Gasoline.
Diesel Engine. Sets the engine type for Diesel and monitors the glow plug input to make sure the
glow plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-in
timer waits 15 seconds before automatically cranking the starter.