Sony 2-680-009-12 (1) - Manual (Page 61)

61 GB
Ad
diti
onal
Inf
o
rma
tion
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see “Error and warning
codes” (page 26) to solve the problem.
DEC. EROR
Appears when a signal the receiver cannot
decode (ex. DTS-CD) is input and “DEC.
PRI.” on the AUDIO menu is set to “DEC.
PCM”. Set it to “DEC. AUTO” (page 34).
PROTECT
Irregular current is output from the receiver.
The receiver will automatically turn off after
a few seconds. Check the speaker
connection and turn on the power again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 23). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
50
Specifications
Amplifier section
Models of area code CEL, CEK, TW, AU
Stereo Power Output
1)
, Reference Power
Output
1)2)
6 ohms 20 Hz – 20 kHz, THD 0.09%
55 W + 55 W, 80 W/ch
6 ohms 1 kHz, THD 0.7%
90 W + 90 W, 100 W/ch
6 ohms 1 kHz, THD 10%
120 W + 120 W, 140 W/ch
Models of area code TH6
Stereo Power Output
1)
, Reference Power
Output
1)2)
6 ohms 20 Hz – 20 kHz, THD 0.09%
40 W + 40 W
1)
,
35 W + 35 W
3)
, 60 W/ch
6 ohms 1 kHz, THD 0.7%
65 W + 65 W
1)
,
60 W + 60 W
3)
, 80 W/ch
6 ohms 1 kHz, THD 10%
85 W + 85 W
1)
,
75 W + 75 W
3)
, 100 W/ch
Models of area code KR
Stereo Power Output
1)
, Reference Power
Output
1)2)
6 ohms 20 Hz – 20 kHz, THD 0.09%
55 W + 55 W
1)
,
50 W + 50 W
3)
, 80 W/ch
6 ohms 1 kHz, THD 0.7%
90 W + 90 W
1)
,
80 W + 80 W
3)
, 100 W/ch
6 ohms 1 kHz, THD 10%
120 W + 120 W
1)
,
100 W + 100 W
3)
,
140 W/ch
To clear See
All memorized settings page 23
Customized sound fields page 46
continued