Sharp DX-B350P - Manual (Page 6)

1-2 Installation Manual
General Safety Guidelines
Introduction
Handling the Printer
• The weight of the printer without toner cartridge and paper is about 22 kg/ 48 lbs. Never
attempt to lift the printer alone.
• To lift the printer, have two individuals facing each other from the front and the rear of the
printer grasp the recessed areas on each side of the printer. Do not lift the printer by
grasping any area other than these recessed areas.
• The machine should be installed near an accessible power outlet for easy connection. For
a complete electrical disconnection, pull out the main plug.
• A small amount of ozone is produced within the printer during operation. The emission
level is insufficient to cause any health hazard. It is advisable to place the printer in a
ventilated area, since the small amount of ozone that is emitted may have an objectionable
odor.
Laser Information for North America
This Digital Equipment is rated Class 1 and complies with 21 CFR 1040.10 and 1040.11 of the
CDRH standards.
This means that the equipment does not produce hazardous laser radiation. For your safety,
observe the precautions below.
• Do not remove the cabinet, operation panel, or any other covers.
• The equipment's exterior covers contain several safety interlock switches. Do not bypass
any safety interlock by inserting wedges or other items into switch slots.
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
Type DX-B350P DX-B450P
Wave length 785nm 785nm
Pulse times 6.7us 8.2us
Output power 0.12mW 0.22mW