Sony STR-DE697 - Manual (Page 28)

masterpage:Left
lename[E:\SEM_Janet\Data_STR-
DE697_revised\J9040016_4252272312DE697GB\4252272312\GB04BSC_STR-DE697-
CEL.fm]
28 GB
model name1[STR-DE697]
[4-252-272-31(2)]
A SW: Lights up when sub woofer selection is
set to “YES” (page 18) and the audio signal is
output from the SUB WOOFER jack.
B LFE: Lights up when the disc being played
back contains the LFE (Low Frequency
Effect) channel and the LFE channel signal is
actually being reproduced.
C SP A/SP B: Lights up in accordance with the
speaker system being used (A or B). Turns off
when speaker output is turned off or when
headphones are connected.
D ; DIGITAL EX: “; DIGITAL” lights up
when the receiver is decoding signals recorded
in the Dolby Digital format.
“; DIGITAL EX” lights up when the
receiver is decoding signals recorded in the
Dolby Digital EX format.
E ; PRO LOGIC II: “; PRO LOGIC” lights
up when the receiver applies Pro Logic
processing to 2 channel signals in order to
output the center and surround channel
signals. “; PRO LOGIC II” lights up when
the Pro Logic II Movie/Music decoder is
activated. However, both indicators do not
light up if both the center and surround
speakers are set to “NO” and “A.F.D. AUTO”,
“DOLBY PL”, “PLII MOV” or “PLII MUS”
is selected.
F DTS-ES 96/24: “DTS” lights up when DTS
signals are input. “DTS-ES” lights up when
DTS-ES signals are input. “DTS 96/24” lights
up when the receiver is decoding DTS 96 kHz/
24 bit signals.
Note
When playing a DTS format disc, be sure that you
have made digital connections and that INPUT
MODE is not set to “ANALOG” (page 35).
G NEO:6: Lights up when DTS Neo:6 Cinema/
Music mode decoding is activated.
H Tuner indicators: Lights up when using the
receiver to tune in radio stations, etc. See
pages 23–27 for tuner operations.
Note
“RDS” appears for models of area code CEL,
CEK only.
I EQ: Lights up when the equalizer is activated.
J D.RANGE: Lights up when dynamic range
compression is activated (page 36).
K COAX: Lights up when the source signal is a
digital signal being input through the
COAXIAL terminal.
L OPT: Lights up when the source signal is a
digital signal being input through the
OPTICAL terminal.
M SLEEP: Lights up when sleep timer is
activated.
About the indications in the display
MEMORY
L C R
SL S SR
SBR SBL SB
SW
LFE SP A
SP B RDS
STEREO MONO D.RANGE EQ
NEO:6
SLEEP OPT COAX 96/24
DIGITAL EX ; PRO LOGIC II DTS-ES ;
q; 8 9 qd
qf
qa qs
2 1 4 3 5 6 7
GB01COV_STR-DE697-CEL.book Page 28 Friday, April 2, 2004 12:21 PM