Sharp DT-300 - Manual (Page 23)

-22
Connecting to a com-
puter with DIGITAL
RGB output Terminal
(DIGITAL INPUT)
1
Slide the “DIGITAL INPUT
TYPE” switch on the back ter-
minal board to “PC”.
2
Connect a DVI cable to the pro-
jector.
3
Connect the above cable to the
computer.
• Secure the connectors by tightening the
thumbscrews.
Note
• Select DIGITAL INPUT mode when con-
necting to digital output terminal of the
computer. (See page 31.)
• Before switching the “DIGITAL INPUT
TYPE” switch and connecting, be sure to
unplug the power cord of the projector
from the AC outlet and turn off the com-
puter to be connected. After making all
connections, turn on the projector and
then the computer.
• Be sure that the computer is the last de-
vice to be turned on after all the connec-
tions are made.
“Plug and Play” function
■ This projector is compatible with VESA-standard DDC 1/DDC 2B. The projector and a VESA DDC
compatible computer will communicate their setting requirements, allowing for quick and easy setup.
■ Before using the “Plug and Play” function, be sure to turn on the projector first and the con-
nected computer last.
Note
• The DDC “Plug and Play” function of this projector operates only when used in conjunction with a
VESA DDC compatible computer.
To DIGITAL INPUT
terminal
To DVI digital output terminal
DVI cable
(sold separately)
Desktop computer
DIGITAL INPUT
TYPE switch
Optional
accessory
DVI cable
Type: AN-C3DV
(9'10'' (3.0 m))
Connecting the Projector to Other Devices
03.10.29, 2:40 PM Page 22