Sharp DT-300 - Manual (Page 33)

-32 -32
Turning the Power off
1
Press on the remote con-
trol or on the projector,
then press or again
while the confirmation message
is displayed, to put the projec-
tor into the standby mode.
• A dimly-lit screen is displayed for a
short time to reduce lamp damage.
Note
• If you accidentally pressed
and do not want to put the projector
into the standby mode, wait until the
confirmation message disappears.
2
Unplug the power cord from the
AC outlet after the cooling fan
stops.
Info
• Do not unplug the power cord dur-
ing projection or cooling fan opera-
tion. This can cause damage due
to the rise in internal temperature,
as the cooling fan also stops.
• When connected to equipment such
as an amplifier, be sure to turn off
the power to the equipment con-
nected first and then to the projec-
tor.
Image Projection
STANDBY button
STANDBY button
03.10.29, 2:42 PM Page 32