Sharp DT-300 - Manual (Page 31)

-30
Image Projection
-30
TEMP. LAMP POWER
LAMP indicator
POWER indicator
ON button
INPUT button
ON button
INPUT buttons
Basic Procedure
Connect the required external equipment to
the projector before operating the following
procedures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 31.
1
Plug the power cord into the
wall outlet.
• The POWER indicator illuminates red,
and the projector enters standby mode.
2
Press on the remote control
or on the projector.
• The blinking green LAMP indicator
shows that the lamp is warming up.
Wait until the indicator stops blinking
before operating the projector.
• If the power is turned off and then im-
mediately turned on again, it may take
a short while before the lamp turns on.
Note
• After the projector is unpacked and
turned on for the first time, a slight
odor may be emitted from the exhaust
ventilative holes. This odor will soon
disappear with use.
When the power is on, the LAMP in-
dicator illuminates, indicating the sta-
tus of the lamp.
Green: Lamp is ready.
Green blinking: Warming up. / Cooling
down.
Red: Change the lamp.
03.10.29, 2:41 PM Page 30