Sharp DT-300 - Manual (Page 43)

-42
Menu Bar Items
Language ( ) English
Deutsch
Español
Nederlands
Français
Italiano
Svenska
Português
Front
Ceiling םFront
Rear
Ceiling םRear
Picture ( )
Tint ם30 מ30
Color ם30 מ30
Sharp ם30 מ30
Contrast ם30 מ30
Bright ם30 מ30
Red ם30 מ30
Blue ם30 מ30
Reset
5500K
6500K
8500K
9300K
10500K
Standard
Cinema 1
Cinema 2
Memory 2
Memory 3
Memory 4
Memory 5
Memory OFF
Cinema 3
7500K
CLR Temp
Gamma
White Emphasis [ON/OFF]
Picture Setting Memory 1
Fine Sync ( )
Auto Sync [ON/OFF]
Clock ם30 מ30
ם30 מ30
ם30 מ30
Phase ם15 מ15
H-Pos
V-Pos
Reset
Special Modes
Signal Info
Resolution
Hor Freq
Vert Freq 640 ן480
37.5 kHz
72 Hz
640 ן480
720 ן480
480P
RGB
Background [None/Blue]
Options ( )
Component
Auto Power Off [ON/OFF]
Menu Position
Menu Color [Opaque/Translucent]
Center
Lamp Timer (Life)
OSD Display [ON/OFF]
Signal Type
Upper Right
Lower Right
Upper Left
Lower Left
Eco Mode [Eco/Standard]
PRJ Mode ( )
10 0
10 0
10 0
10 0
10 0
10 0
■ INPUT 1 / 2 / DIGITAL INPUT Mode
Main menu Sub menu Main menu
Note
• The resolution, vertical frequency and horizontal
frequency figures displayed above are for
example purposes only.
• “Color”, “Tint”, and “Sharp” do not appear when
“RGB” is selected in INPUT 2 mode.
• “Signal Type” is not displayed when using
INPUT 1.
• “Color”, “Tint”, “Sharp”, “Clock”, “Phase”, “H-
Pos”, “V-Pos”, “Special Modes” and “Auto Sync”
cannot be used in the DIGITAL INPUT mode.
• “Clock”, “Phase” and “Auto Sync” cannot be
used in the Component mode.
03.10.29, 2:43 PM Page 42