Sony CMT-SE1 - Manual (Page 14)

14 GB
To enhance your system, you can connect optional components. Refer to the operating instructions
provided with each component.
A MD (TAPE) IN jack (stereo mini
jack)
Use audio cord (not supplied) to connect an
optional analog component (MD deck or tape
deck, etc.) to this jack. You can then listen to the
sound from the component.
B MD (TAPE) OUT jack (stereo
mini jack)
Use audio cord (not supplied) to connect an
optional analog component (MD deck or tape
deck, etc.) to this jack. You can then listen to the
sound through this system.
C CD OPTICAL OUT DIGITAL
jack
Use a digital optical cable (square, not supplied)
to connect an amplifier, MD deck, or DAT deck
with a digital optical input jack. Digital signal is
output only when the system function is set to
CD. If the jack is covered with a cap, remove it
before use.
Optional Components
Hooking up optional components
Optional digital component
From the audio
output jack of an
optional analog
component To the digital
input jack of an
optional digital
component
Optional analog component
To the audio
input jack of an
optional analog
component