Sony ST-D777ES - Manual (Page 12)

12 GB
Advanced Tuner Operations
Naming the Preset Stations
You can assign a name of up to 16 characters long to
each preset station except DAB and FM RDS stations.
When the station is tuned in, the station name will
appear.
1
Tune in the preset station you want to name.
2
Press CHARACTER.
The cursor flashes in the display.
3
Turn TUNING/SELECT to select a character.
4
When the character you want appears, press
CHARACTER to move the cursor into position for
the next character.
If you make a mistake
Press CHARACTER repeatedly until the character
you want to change flashes (every time you press
CHARACTER, the next character flashes). Then
turn TUNING/SELECT to select a new character.
5
Repeat steps 2 and 3 until the station name you
want appears in the display.
6
Press MEMORY.
“MEMORY” appears along with the preset
number.
7
Press ENTER.
“PRESET Memory OK” appears.
z When you name the station by Automatic tuning or
Manual tuning
After the step 6 above, “MEMORY” appears along with
the lowest vacant number to indicate that the tuner
stores the station.
Notes
• The display returns to normal display mode if you stop
assigning names for more than 60 seconds. If this happens,
start again from the beginning.
• If you name a station which has a preset name already, the
previous preset name is deleted.
• “No Name” appears when you display a preset station
without the preset name.
• You cannot use “ ” (blank space) only for the preset name.
z If the STEREO indicator remains off
Press MONO/SC when an FM stereo broadcast is
received.
z If an FM stereo programme is distorted
Press MONO/SC to change to monaural (MONO). You
will not have the stereo effect but the distortion will be
reduced. To return to stereo mode, press this button
again.
z When you preset a FM station, current settings of
ANTENNA ATTENUAT, IF BAND WIDTH and FM mode
are stored simultaneously
If you want to store other settings, change settings
according to the procedures in “Tips for Better FM
Reception” on page 18 after performing step 3, then
perform step 4.
When you want to change the settings for the preset
station, tune the station and change the setting. Then,
press MEMORY and ENTER.
Note
You cannot preset the secondary component (SC) of a DAB
broadcast. Store the service which contains the desired
component, then switch the component by pressing MONO/
SC when you want to receive the component.
MEMORY TUNING/SELECT
ENTER CHARACTER