Spalding M6711041 - Manual (Page 14)

14
ID# M6711041 02/07
4.
4
5
6
WOOD SCRAP
(NOT SUPPLIED)
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
Align dimple of middle pole section (5) into trough
of bottom pole section (6) as shown.
IMPORTANT!
HOLE
DIMPLE
Bottom pole
5"
1-1/2"
ID
STICKER
Bottom pole
Bounce top and middle pole assembly (4 & 5) onto bottom pole section (6) using a wood scrap as shown.
Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the
bottom pole.
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE
POLE SECTIONS SHOULD HAVE
A 3-1/2" MINIMUM OVERLAP,
LEAVING 1-1/2" BETWEEN THE
OVERLAPPING POLE AND THE
IDENTIFICATION STICKER.
CAUTION!