Sharp DV-RW2U - Manual (Page 53)

53
7
Press RETURN to return to the
normal screen.
• The display appears shown below.
T I M E R O N / O F F B U T T O N
F O R T I M E R R E C O R D I N G .
8
Press TIMER ON/OFF to enter
the timer standby mode.
• TIMER indicator on the front of the
recorder will light up.
• Timer recording will not work if the
recorder is left on.
NOTE
• If you select “DAILY” in step 4, the recorder
will record the program Monday-Sunday at
the same time.
If you want to record Monday-Friday or
Monday-Saturday, select “DATE” with \
\ \ \ \ / | | | | |
and change it to “MO-FR” or “MO-SA” with
'
' ' ' ' / " " " " " in step 5.
• In step 5, input the channel number you
want to record. Once the preset channel
has been input, you will not need to set the
preset channel for that station again.
• In step 4, if the recorder cannot decode the
PlusCode number, or if the combination of
PlusCode number and Program mode does
not exist, then “ERROR” will appear. To
correct, press ERASE and re-enter the
PlusCode number.
• The following causes are possible when the
TIMER indicator is blinking or “ERROR” is
displayed when TIMER ON/OFF has been
pressed.
• A recording has been programmed
having a recording time of 1 minute
• Inadequate available disc space
• The disc is protected
• No disc is loaded in the recorder
• Disc identification is not finished
Repeat the procedure after checking the
recording time and disc.
Checking/Cancelling the VCR
Plus+ Programming System
Use the procedure described in “Confirming/
Cancelling Timer Program” to confirm or
cancel program data (See page 59).
Timer Recording with VCR Plus+ ® System
EDIT
100
OPEN/
CLOSE POWER
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE MENU
ANGLE
SETUP/
FUNCTION DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS+
TIMER PROG.
REC MODE
PROGRAM AM/PM ERASE
STILL/PAUSE REC
PLAY
STOP
SLOW SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER INPUT VOL
CH
TV CONTROL
ZOOM INPUT
DV_RW2U#p45-53.p65 03.1.9, 7:39 PM 53