Sharp DV-RW2U - Manual (Page 99)

99
Recording Material from
External Equipment
VR MODE
DVD RW
VIDEO MODE
DVD RW DVD R
You can record material from equipment connected to one of
the external input jacks of this recorder (IN 1, IN 2 or IN 3).
1
Setup
1 Connect the equipment to an external input jack
of this recorder.
POWER OPEN/CLOSE CHANNEL TIMER ON/OFF
REC
STOP PLAY STILL/PAUSE SKIP
DISC TIMER
AV AUTO REC
STANDBY
TIMER DISC IN
LINE IN 2 L(MONO)-AUDIO-R VIDEO S-VIDEO DV IN/OUT
RESET
External equipment
The Recorder
To VIDEO/AUDIO
IN jacks
To VIDEO/AUDIO
output jacks
Video/Audio cable
(Supplied)
2 Place a disc for recording in this recorder.
2
Select the external input audio.
• Refer to the section on “EX. AUDIO” (page 86) or
the section on “D-MONO REC” (page 86).
3
Press INPUT.
• The setting changes in the order of DV (DV Input),
L 1 (External Input 1), L 2 (External Input 2), L 3
(External Input 3), Channel and then back to DV (DV
Input) each time this is pressed.
4
Perform the procedure for recording with this
recorder.
NOTE
• Material protected with a copy guard cannot be
recorded. In addition, proper images may not be able to
be viewed even when only viewing such material without
recording.
Connecting to Audio Equipment
DV_RW2U#p86-99.p65 03.1.9, 7:53 PM 99