Sharp DV-RW2U - Manual (Page 62)

62
Problems of Timer Recording
Blinking the TIMER Indicator
Timer recording cannot be performed in the situations shown below. Check the contents of the error and reprogram timer
recording correctly. When an error occurs, the TIMER indicator on the recorder blinks for about 5 seconds.
NOTE
• Press ■STOP when you want to discontinue recording while timer recording is in progress. Timer recording is canceled
when ■STOP is pressed. When there are other timer programs, enter standby by pressing TIMER ON/OFF.
• When timer programs are programmed that have the same recording starting date and time, the first timer program is
overwritten.
When Timer Recording Times Overlap
Problem
Timer recording times overlap
Helpful Hint
■ If two timer recording times overlap, the second timer program starts after the first
timer program is finished.
<Recording Times set> <Recording actually made>
7:00 8:00 8:30 10:00 7:00 10:00
➜
First timer program
Second timer program Second timer program
Example:
7:00 8:30 10:00
First timer program
NOTE
• When multiple timer programs have been set and the timer recording times overlap or the ending time of the first timer
program overlaps the starting time of the second timer program, disc information is written and the second timer program
starts after the first timer program is finished. Consequently, the start of the second timer program is delayed by a
maximum of about 1 minute.
TIMER
indicator
is
blinking.
Timer
recording
does not
work.
Front Panel Display Causes
• There is no disc loaded
• A non recordable disc is
loaded
• There is enough blank
space on the disc
• The disc is unplayable
• The disc that’s loaded is
protected
• Timer Recording is full
• The clock has not been
set.
• The channel is incorrect
• The Recording time is set
at 1 minute
Solution
• Load a disc for recording, and after
the disc has finished being identified,
press TIMER ON/OFF to enter
standby.
• When a disc for recording has already
been loaded in the recorder, turn on
the power and after the disc has
finished being identified, press TIMER
ON/OFF to enter standby.
• Enter standby after either canceling the
disc protect function or loading a different
disc for recording in the recorder.
• Repeat timer recording after deleting
some of the timer program.
• Repeat timer recording after setting
the clock.
• Check the channel that has been
programmed for timer recording.
• Reset the recording time to 2 minutes
or more.
• Repeat timer recording after setting
the clock.
• Program timer recording after the
timer recording menu or simple
recording menu has finished.
• Repeat timer recording after deleting
the timer program.
Setting correctly
TIMER indicator
lights up.
• The clock on the recorder is not set
• Timer Recording or Simple Recording Timer has
been set
• Timer Recording is full
DV_RW2U#p62-70.p65 03.1.14, 9:34 AM 62