Sharp DV-RW2U - Manual (Page 93)

93
Playing 2 channel audio with an
Analog Connector
Connecting to Audio Equipment
Playing Dolby Digital
(5.1 channel) and DTS audio with a
Digital Connection
• Connecting an amplifier with a Dolby Digital/DTS digital
surround processor or a Dolby Digital/DTS digital
surround decoder to the recorder’s optical digital jack
provides richer, more powerful audio play.
• To use DTS digital surround, press AUDIO to select DTS
audio.
■ Connection to a processor or amplifier with a optical
digital input jack
1
COMPONENT OUT (480I/480P)
Y
P B
P R
IN FROM ANTENNA
VHF/UHF/CATV
OUT TO TV
DIGITAL OUT
OPTICAL
IN 1 AUTO REC
IN 3
OUT
R-AUDIO-L VIDEO S-VIDEO LINE
(White) (Red)
(White) (Red)
AUDIO cable
(commercially available)
To AUDIO
output jacks
To amplifier
audio input jacks
Audio equipment, etc.
Jack and Plug Colors
Audio Left: White
Audio Right: Red
Dolby Digital (5.1ch)/
DTS processor or amplifier
Optical digital cable
(commercially available)
To DIGITAL OUT
OPTICAL terminal
To optical digital
input terminal
1
COMPONENT OUT (480I/480P)
Y
P B
P R
IN FROM ANTENNA
VHF/UHF/CATV
OUT TO TV
DIGITAL OUT OPTICAL
IN 1
AUTO
REC
IN 3
OUT
R-AUDIO-L VIDEO S-VIDEO LINE
NOTE
• When connecting the audio equipment to the analog
connection, we recommend that you set the
“DD LEVEL” in “PLAYBACK SETUP” to “OFF” (See page 81).
Important!
• When using this connection, set the “ Digital OUT” in
“PLAYBACK SETUP” to “ DIGITAL” (See page 81).
NOTE
• To play a disc recorded with DTS, you need to use DTS
processor or amplifier.
• This connection is not possible if the processor or
amplifier to which you want to connect does not have a
optical digital input jack.
• Refer to the operation manual for the processor or
amplifier for information about connecting to it.
DV_RW2U#p86-99.p65 03.1.9, 7:52 PM 93