Sharp DV-RW2U - Manual (Page 55)

55
9
Press SET/ENTER.
• To program additional timer settings,
press SET/ENTER and repeat steps
3–9.
10
Press RETURN to finish
settings.
11
Press TIMER ON/OFF to enter
the timer standby mode.
• The power turns off, and the recorder
enters the timer standby mode (the
TIMER indicator on the recorder lights
up).
• During playback, the power does not
turn off, but the timer recording will be
set.
NOTE
• If the power is interrupted for more than
1 hour (power failure, etc.) during timer
recording, the Auto Clock Setting will reset
the time after the power is returned (the
timer indicator on the Front Panel Display
will blink.) but the timer settings will be
canceled.
• Number buttons can be used instead of
' ' ' ' ' / " " " " " to set the data.
• To stop timer recording, press ËSTOP.
• If a button is not pressed within 3 minutes
during the setting procedure, the screen
will return to the normal screen.
• There are two timer setting screens (1/2, 2/2).
• The following causes are possible when the
TIMER indicator is blinking or “ERROR” is
displayed when TIMER ON/OFF has been
pressed.
• A recording has been programmed
having a recording time of 1 minute
• Inadequate available disc space
• The disc is protected
• No disc is loaded in the recorder
• Disc identification is not finished
Repeat the procedure after checking the
recording time and disc.
Timer Recording
EDIT
100
OPEN/
CLOSE POWER
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE MENU
ANGLE
SETUP/
FUNCTION DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS+
TIMER PROG.
REC MODE
PROGRAM AM/PM ERASE
STILL/PAUSE REC
PLAY
STOP
SLOW SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER INPUT VOL
CH
TV CONTROL
ZOOM INPUT
DV_RW2U#p54-61.p65 03.1.14, 9:33 AM 55