Sub-Zero 315 - Manual (Page 11)

Once you have located the proper position for the hard-
ware, mark the holes, remove template, and drill pilot
holes for mounting of the hardware. We recommend start-
ing the first few holes, positioning the hardware, drilling
remaining pilot holes, and securing the mounting brackets
with the #8 x 1/2" screws.
Install the door panel by engaging the tabbed bracket to
the door first and then sliding the hinge side hardware
over the positioning screws. You will have a 1/4" inch
adjustment, up and down, side to side, with this hardware.
Once you have the door in place, attach the remaining #8
x 1/2" screws to the hinge side mounting bracket and
install decorative caps.
11
INSTALLATION
Door Panel Installation
Door Panel–15 lb. weight limit
Remove the handle side bracket attached to the front of
the door and set aside.
Place the door panel lying face down on a protected sur-
face to ensure the front is not scratched or damaged.
Position the plastic template provided flush with the upper
edge of the door. Be sure you are following the exact loca-
tion for the RH or LH door position. See the following illus-
trations.
IMPORTANT NOTE: Remember you are viewing the door
panel from the back side in the illustrations. The overall
size of the panel shown is the minimum size necessary to
cover the door of the unit. The exact measurements of your
door panel may vary depending on the particular installa-
tion you are following.
CAUTION
Where the reveal on the hinge side of the door panel
is less than 1/4", and the panel has a square corner,
severe finger pinching or damage to the appliance
may occur.
Right-Hand Door Panel Left-Hand Door Panel
Lower Bracket
Top Edge of Door Panel
Drilling Template
Door Panel
Upper Bracket
Right Hand Swing
Left Hand Swing
Upper Bracket
Handle Side Bracket
Right Hand Sw
ing
Left Hand Sw
ing
Handle Side Bracket
CAUTION
Before d rillin g inset p anels,
determ ine fin al place ment so screw s fall w ithin ra ils
or style s.
Flush with Top and Side
of Panel
Template Positioning