Installation – Sub-Zero 315 User Manual

Page 6

Advertising
background image

6

INSTALLATION

Plumbing

Model 315 – Gravity Drain Model

The drain and inlet water tubes must be plumbed before
connecting to the ice maker. All horizontal runs of drain
lines must have a 1/4" per foot fall. An air gap will likely
be required between the ice maker drain tube and the
drain/waste receptacle. A stand pipe with a trap below it
would be acceptable for the drain/waste receptacle.

IMPORTANT NOTE: Poor draining will cause a high rate
of ice melting in the bin.

1)

Place ice maker in front of installed location. Adjust
leg levelers to approximately correct position.

2)

Remove door with hinges, control knob, control panel,
access panel and lower stainless face plate.

3)

Route water inlet line, which should be a 1/4" O.D.
copper tube, from wall through ice maker to the front.

4)

Route drain line from wall position through ice maker.

NOTE: if using a long horizontal run (more than 5 feet)
the drain should be vented at back of cabinet.

5)

If electrical outlet for ice maker is behind the cabinet,
plug in the ice maker now.

6)

Push ice maker into installed position.

7)

Cut off water inlet line at required length.

8)

Flush water line. Place flare nut on inlet water line and
flare the end of the copper tube.

9)

Attach flare nut to the male flare on the inlet water
valve.

10) Cut off the drain tube to the required length.

11) Connect the 5/8" drain tube to the bin drain fitting at

the bottom of the bin. Secure with hose clamps.

Be certain that the drain tube is pushed up well past the
barbs on the drain fitting. If needed to ease installation,
soak the drain hose in hot water just before connecting to
the fitting.

12) Turn on the water supply and check for leaks.

13) Replace door with hinges, control knob, control panel,

access panel and lower stainless face plate. Level as
needed.

IMPORTANT NOTE: All plumbing must meet local codes.

15

1

/

4

"

(387) MIN.

FRONT VIEW

SHUT-OFF

VALVE

WATER

FILTER

WATER

INLET TUBE

DRAIN

TUBE

TOP VIEW

SHUT-OFF

VALVE

WATER

FILTER

34

1

/

2

"

(876) NOMINAL

33

3

/

4

"

(857) MIN.

15

1

/

4

"

(387) MIN.

24"

(610)

1

/

8

"

(3)

WATER

INLET

TUBE

DRAIN

TUBE

LOCATE DRAIN

WITHIN 2" DIA.

AREA 23" BACK

FROM FRONT

OF UNIT

PRE-INSTALLATION SPECIFICATIONS

MODEL 315 (GRAVITY DRAIN)

Drain Tube

Clamp

Drain

Stand Pipe

Drain Tube Detail

Advertising