Sony KP-65XBR10W - Manual (Page 34)

30
D:\810nouhin\4080199111\408019911KP57XBRUC\02US-COV-KP57XBRUC\08CTV.fm masterpage:Left
Model name1[KP-57XBR10W] Model name2[KP-65XBR10W]
[4-080-199-11 (1)]
Notes:
• Depending on the picture format, black bands may
be present on the top and bottom of the screen.
• For ZOOM and WIDE ZOOM modes you can
adjust the vertical position of the picture. (see “V
CENTER” on page 41)
Watching Two
Programs at One Time
— PIP
The Picture-in-Picture (PIP) feature allows you to
view two channels simultaneously, one in the full
size “main” picture and one in a smaller “window”
picture.
You can move the window picture to any location
on the screen.
Using the yellow labeled buttons Using the yellow labeled buttons Using the yellow labeled buttons Using the yellow labeled buttons
for PIP operations
for PIP operations for PIP operations for PIP operations
REFER TO THE
ILLUSTRATION OF THE
REMOTE CONTROL ON THE INSIDE FRONT
COVER OF THIS MANUAL AS YOU REVIEW THE
FOLLOWING DESCRIPTION
Tip z
If you press RESET in PIP mode, the window picture
will move to the bottom right (factory-preset
location).
Press to display a window picture.
Each time you press this button, the picture size
will change (1/4
t 1/9 t 1/16).
Press (OFF) to close the window picture.
Press to change the location of the window picture
(counterclockwise) around the main picture.
Press to select either the main or window picture in
order to change the TV channel or video source
using the white labeled buttons below. The symbol
“
b” (or “B”) will appear to indicate which
picture’s channel or input mode can be changed.
Caution about continued wide screen
mode usage for 4:3 aspect ratio pictures
This projection TV was designed primarily for
viewing TV broadcasts in wide screen mode (16:9
aspect ratio pictures). Consistent and exclusive
viewing of 4:3 aspect ratio programs in NORMAL
mode will lead to permanent imprinting of the
gray band on both sides of the picture.
Therefore, when you watch conventional 4:3 ratio
TV programs, we recommend you select WIDE
ZOOM mode by using WIDE MODE button.
Note:
• The PIP feature is not available for the inputs
from VIDEO 5 (DTV) IN.
10 10
6
10
The symbol “ b ” or
“ B ” indicates which
picture’s TV channel
or input source can
be changed.
The symbol “ 9 ”
indicates which
picture’s sound is
being received.
Main
picture
TV channel or
input-source
mode for the
main picture (It
will dim in
about 3
seconds.)
TV channel or
input-source
mode for the
window picture
(It will dim in
about 3
seconds.)
Window picture
POSITION
ACTIVE