Sony KP-65XBR10W - Manual (Page 21)

17
D:\810nouhin\4080199111\408019911KP57XBRUC\02US-COV-KP57XBRUC\06INT.fm masterpage:Right
Model name1[KP-57XBR10W] Model name2[KP-65XBR10W]
[4-080-199-11 (1)]
In
s
ta
lli
ng
a
n
d
C
o
n
n
e
c
ting
th
e
Projec
tion
T
V
Disconnect all power sources before making any connections.
SELECT OUT allows you to use a second VCR to
record a program being played by the primary
VCR or to perform tape editing and dubbing.
1 Connect the VCR intended for playback using
the connection instructions on page 10 of this
manual.
2 Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR intended
for recording to AUDIO and VIDEO OUT of
SELECT OUT on the projection TV.
Notes:
• Do not change the input signal while editing
through SELECT OUT.
• When connecting a single VCR to the projection
TV: if VCR LINE OUT is connected to VIDEO IN
on the projection TV, do not connect the SELECT
OUT on the projection TV to the VCR LINE
INPUT (see right). Doing so will cause program
interference and other viewing problems.
• You can select the output signal from SELECT
OUT of the SET UP menu. (see “SELECT OUT”
on page 45)
• When the projection TV turns off, the signal is not
output through SELECT OUT.
Connecting Two VCRs for
Tape Editing
S VIDEO
VIDEO
AUDIO
L
R R
VIDEO
(MONO)
IN
IN
CONTROL S
IN OUT
OUT
VIDEO 4
VIDEO 1 VIDEO 3
VIDEO 5 (DTV) SELECT
Y
P B
P R
Y/G
HD VD
P B /B
P R /R
L
(MONO)
R
L
AUDIO
AUDIO COMPONENT
VHF/UHF
AUX
AUDIO R AUDIO L VIDEO
LINE
OUT
OUT
IN
AUDIO R AUDIO L VIDEO
LINE
IN
OUT
IN
(Rear of projection TV)
AUDIO-R
VCR (for playback)
AUDIO-L
2
VIDEO
VMC-810S/820S
(not supplied)
VIDEO
AUDIO-L
AUDIO-R
VCR (for recording)
VMC-810S/820S
(not supplied)
1
LINE
OUT IN
SELECT
OUT VIDEO IN
Indicates direction
of signal
(Rear of projection TV)