Sony VGC-RC300 User Manual
Page 138
138
Troubleshooting
What should I do if a BIOS error appears when I turn on my computer?
If the message "Press <F1> to resume, <F2> to setup" appears at the bottom of your computer screen, follow these steps:
1
Press the F2 key when the VAIO logo appears.
The BIOS setup screen appears.
2
Press the
,
key to select the Exit menu.
3
Press the
m
key to select Load Optimal Defaults.
4
Press the Enter key.
The Load Defaults? window appears.
5
Press the Y key on the keyboard.
6
Select Exit Saving Changes and press the Enter key.
The Exit Saving Changes? window appears.
7
Press the Y key on the keyboard.
Your computer restarts.
If this occurs frequently, contact an authorized Sony Service Center. To find the nearest center or agent, visit the Sony online
support Web site.
What should I do if VAIO power indicator lights but my computer screen stays blank?
Follow these steps:
1
Press the power button for more than four seconds to check that the VAIO power indicator goes out. Then turn on your
computer again.
2
If your computer screen still stays blank, unplug the power cord and leave the computer for about a minute. Then plug in
the power cord and turn on the computer again.