Sun Microsystems 2.0 - Manual (Page 19)

Installing the Adapter 2-3
2
2.3 Watching Network Activity
Make sure that you are connected to an active network.
♦ You can watch network activity or incoming network packets by typing
watch-net-all :
Note – The network speed is the same as the speed of the hub to which your
system is connected. See Chapter 3, Section 3.6, “Post-Installation Procedures
(Optional)” for more detailed information on speed selection.
Where to Proceed
•
See Chapter 3, “Installing SunFastEthernet Adapter 2.1 Software On Solaris
2.x Systems” if your system is running Solaris 2.3, 2.4 or 2.5.
•
See Chapter 4, “Installing SunFastEthernet Adapter 2.1 Software On Solaris
1.1.1 and 1.1.2 Systems” if your system is running Solaris 1.1.1 or 1.1.2
(SunOS versions 4.1.3_U1 and 4.1.4).
ok watch-net-all
/iommu@f,e0000000/sbus@f,e0001000/SUNW,hme@3,8c00000
Internal loopback test -- succeeded.
Transceiver check -- Using Onboard Transceiver - Link Up.
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet. 'X' is a Bad Packet.
Type any key to stop.
...........