Press the control-c keys after typing device-end, At the ok prompt, type, Press the stop-a keys to get to the ok prompt – Sun Microsystems 2.0 User Manual
Page 49
Installing SunFastEthernet Adapter 2.1 Software On Solaris 1.1.1 and 1.1.2 Systems
4-15
4
3. Type the following exactly as shown, spaces and quotation marks
included, pressing the Return key at the end of lines
0
,
1
and
2
:
4. Press the Control-C keys after typing
device-end
.
5. At the
ok
prompt, type:
Your system will reset and the banner will appear.
6. Press the Stop-A keys to get to the
ok
prompt.
7. At the
ok
prompt, type
show-devs
to list your system devices and verify
that the name property was changed correctly.
You should see the full path of the
hme
device, excluding
SUNW,
prior to
hme
,
similar to the example below:
8. At the
ok
prompt, type:
0: probe-all install-console banner
1: cd
(full path name of the hme device)
2: “ hme” nameprop
3: device-end
ok nvstore
ok reset
/iommu@f,e0000000/sbus@f,e0001000/hme@3,8c00000
ok boot
(full path name of the hme device)