Sony MZ-RH10 - Manual (Page 75)

75
While editing
Symptom Cause/Remedy
“NOT ENOUGH
POWER TO EDIT”
appears and editing
cannot be done on a
1GB Hi-MD disc. • Editing is not possible when using a 1GB Hi-MD disc even when the
battery level indication shows enough power remaining while the
recorder is stopped or playing. This is because of a mechanism that
disables editing when the remaining battery power is estimated by the
recorder to be insufficient due to the high power consumption required
for 1GB Hi-MD disc editing.
, Connect the AC power adaptor to the recorder or insert a fully
charged rechargeable battery or a new alkaline dry battery.
The lid does not open. • The recorder is saving the contents of an editing operation. The lid will
not open until “SYSTEM FILE WRITING” disappears from the
display.
Editing cannot be
done. • The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
Non-audio data
cannot be erased. • Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your computer.
If it is okay to delete the contents, then perform the Format
function (page 56).
Tracks cannot be
combined. • This is due to the MiniDisc system limitations. When the tracks are
scattered and the length of each track is short*, you may not be able to
combine the tracks.
* Combining tracks of the following lengths may not be possible.
Hi-MD mode
Linear PCM: 9 seconds or less
Hi-SP: 8 seconds or less
Hi-LP: 32 seconds or less
MD mode
SP: 12 seconds or less
LP2/Monaural: 24 seconds or less
LP4: 48 seconds or less
• You cannot combine tracks recorded in different recording modes,
e.g., a track recorded in stereo and a track recorded in monaural; nor
can you combine a track recorded with digital connection and a track
recorded with analog connection.
The disc cannot edit
on other component. • The component does not support Hi-MD.
, Edit on other component that support Hi-MD.
While using group function
Symptom Cause/Remedy
The group function
does not operate. • While using a disc without group setting, an attempt was made to select
some group-related menu.
, Use a disc with group setting.