Sony BRS-200 - Manual (Page 51)

51
Basic Setups for the Switcher
Chapt
er
3
Pre
par
at
ion
s
Setting Up the Video Input Signals
To identify the video input signals (menu page 921)
You can name a video signal input to the switcher.
1
Display menu page 921.
For the procedure for displaying the menu, see “Menu Operation” on page
46.
2
Turn the F1 control to select the video input signal to be named under
“SIGNAL.”
IN 1 to IN 4: to name the video signal input from any of the SDI IN 1 to 4
connectors at the rear of the Processor Unit
IN 5 to IN 8: to name the video signal input from the input connector on the
interface board installed in the IN1 card slot at the rear of the Processor
Unit (When the BRSA-20HSD1 is installed, select any of “IN 5” to “IN
8.” When the BRSA-20DD1 is installed, select “IN 5.”)
IN 9: to name the video signal input from the input connector on the
interface board installed in the IN2 card slot at the rear of the Processor
Unit
FM 1, FM 2: to name frame memory image 1 or 2 stored in the Processor
Unit
MAT1, MAT2: to name color matte 1 or 2 used for a background image
CLBR: to name color bars used for adjustment and test transmission
3
Set the name of the video input signal within four characters under
“RENAME” using the F2 and F3 controls.
1 Press the F2 control to highlight the first character of the registered video
input signal name.
2 Turn the F2 control to change the highlighted character.
You can select alphanumeric characters and symbols.
For selectable characters, see “Selectable characters” on page 52.
3 Turn the F3 control to change the highlighted character and the F2
control to change the character.
4 Repeat steps 2 and 3 to set the name within four characters.
• If the highlighted characters exceed four by turning the F3 control, the present
displayed name is defined as the name of the selected video input signal. To
highlight the characters again, press the F2 control.
• The displayed name under “RENAME” and the selected signal under
“SIGNAL” are changed relative to each other. If you press the F2 control
when no highlighted character is displayed under “RENAME”, the video
input signal under “SIGNAL” will be changed.
INPUT SIGNAL RENAME <=> 1/6
NAME IN 1 (4 chars.) 921
Notes