Setting the length of alarm beeps – Sharp R-208S User Manual
Page 126
Advertising
18
SETTING THE LENGTH OF ALARM BEEPS
You can select the length in seconds of the alarm beeps (emitted at the end of transmission and reception) following
the procedure below.
1
Press the [MENU] key.
2
Press the [
] key (
) or [
] key (
)
until "4:USER PROGRAM" appears,
and then press the [ENTER] key.
3
Press the [
] key (
) or [
] key (
)
until "17:BEEP LENGTH" appears,
and then press the [ENTER] key.
4
Press the [
] key (
) or [
] key (
)
to set the alarm beeps to the desired
length or to turn them off.
The selections are as
follows:
1:3SEC
2:1SEC
3:NO BEEP
5
Press the [ENTER] key.
6
Press the [MENU] key.
Press the [MENU] key to
exit.
"4:USER PROGRAM"
Selection
"17:BEEP LENGTH"
Selection
!AR-FX13_sec.book 18 ページ ２００７年１１月２８日 水曜日 午後４時２２分
Advertising