Siemens se5880 - Manual (Page 22)

SIEMENS 16
Chapter 3
Easy Setup
This chapter describes how to define router configuration settings using the Easy Setup Wizard. These
settings control access to the Wide Area Network (WAN) and Local Area Network (LAN). During the Easy
Setup procedure, you will be prompted to specify configuration parameters that may require information from
your service provider.
Access Easy Setup Wizard
To access the Easy Setup Wizard, click Easy Setup in the left navigation pane of the Router Information
window. This wizard will walk you through the configuration screens necessary to setup the router. You can
exit the Easy Setup Wizard at anytime by clicking Cancel on the bottom of the configuration page. If the wizard
is cancelled, no changes will be made and you will need to begin again.
Untrusted Interface Configuration
When you click Easy Setup in the
left navigation pane of the Router
Information page, the Untrusted
Interface Configuration page is
displayed. This page is used to
enter information for the
Untrusted (WAN-side) Ethernet
Interface that will communicate
with the Internet access device
(for example, broadband modem
or similar). Note that PPPoE IP
Address and PPPoE IP Gateway
are displayed only when Dial
backup is enabled.
1. Select one of the following
connection methods.
• Using PPPoE:
Uses the Point-to-Point
Protocol (PPP) to establish
the connection. Refer to
Using PPPoE for
instructions on providing
information on this page for this method.
• Not Using PPPoE
Establishes the connection based on IP addressing. This option routes all IP packets for remote hosts to
the WAN. Refer to
Not Using PPPoE for instructions on providing information on this page for this
method.