Siemens se5880 User Manual
Page 38
SIEMENS se5880 Ethernet Security Router
User’s Guide
Chapter 5 Advanced Setup
DMZ
SIEMENS
32
6. To change the server status, select Enable or Disable from LAN DHCP Server Status. Disabled, the
router will not act as a DHCP server.
7. To change the start and ending address range of the IP address pool, enter the starting address in First IP
Address and the ending address in Last IP Address.
8. Click Apply.
Note that a list of network clients that are currently leasing their IP addresses from the pool are shown in
Current DHCP Leases List: From left to right, the following information is presented for each client:
•
Client IP: The leased IP address assigned to the specific client.
•
State: Whether the IP address is enabled or disabled.
•
Host Name: Name of the host leasing the specific IP address.
•
Expires (mm/dd/yy): Date when the IP address lease will expire. At that time (if not before), the leased IP
address will be freed for re-assignment, and the network client will need to request a new IP address from
the router.