Sharp 32N-S500 - Manual (Page 21)

21
2
VOL
+
VOL
—
1 2 3
4 5 6
7 8 9
0 100
MENU
FLASHBACK
VOL
—
CH
CH
VOL
+
ENTER
A B C D
PERSONAL PREFERENCE
AIR CABLE STD CABLE IRC CABLE HRC
CH
CH
VOL
—
VOL
+
VOL
—
VOL
+
CH
CH
VOL
—
VOL
+
CH
CH
Set Up (Continued)
2 Saving Broadcast TV channels to memory.
1 Repeat steps 1 to 3 of EZ SETUP.
2 Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ : ”
mark to “CH SEARCH”.
3
Press VOL (+) or (–) to access CH SEARCH mode.
4 Press VOL (+). The tuner will search through all
available channels in your area and add them into
the TV’s memory.
TO STOP SEARCH
Press VOL (–). CH SEARCH will stop at the current
channel and will not add any higher channels.
5
Press MENU to exit.
• If you press VOL (+) again while in the CH SEARCH mode, auto-
program will start again, and the previously memorized channels
will be lost.
3 Adding weak or additional channels or erasing unwanted
channels from TV memory.
1
Repeat steps 1 to 3 of EZ SETUP.
2 Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ : ”
mark to “CHANNEL MEMORY”.
(SET UP mode)
REMOTE
KEYPAD
VOLUME
(+)/(–)
CHANNEL UP
(
8 )/DOWN ( 9 )
MENU
7
Once EZ SETUP is completed, the lowest channel number
memorized will be displayed. (Ex. 2CH)
L CHANNEL SETTING
If EZ SETUP does not memorize all the channels in your
region, follow the instructions below to manually memorize
the channel.
1 AIR/CABLE setting
1
Repeat steps 1 to 3 of EZ SETUP.
2 Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ : ”
mark to “AIR/CABLE”.
3 Press VOL (+) or (–) to access AIR/CABLE select
mode.
4
Press VOL (+) or (–) to select your TV signal mode.
5 Press MENU to exit.
• Receivable channels of your TV set are:
AIR channels:
VHF: 2 through 13.
UHF: 14 through 69.
CABLE channels:
1 (HRC and IRC mode only)
2 through 125 (STD, HRC and IRC)
(SET UP mode)
(TV signal mode)
(AIR/CABLE SELECT mode)
(SET UP mode)
(CH SEARCH mode)
NOTE:
NOTE: