SpectraLink 150 M3 MCU - Manual (Page 46)

SpectraLink Corporation Link WTS Installation and Operation
Part Number: 72-0075-01-C-W.doc Page 35
8.4 Replace a Wireless Telephone
If a Wireless Telephone breaks or needs to be replaced, the old Wireless Telephone must
be deleted and the new Wireless Telephone added.
Delete Old Wireless Telephone
1. Make sure all unregistered Wireless Telephones are OFF . If this is not done an
unregistered Wireless Telephone may unintentionally register to an available line.
2. Move the mode switch to the REGISTER position on the MCU.
3. Press the STEP button until the LED for the line to be deleted is flashing red.
4. Press the DEL/ENTER button.
You can now register a new Wireless Telephone or return the mode switch to the NORM
position.
Register New Wirele ss Telephone
1. Make sure all unregistered Wireless Telephones are OFF .
2. Move the mode switch to the REGISTER position.
3. Press the STEP button until the desired line to be registered is flashing red. Only
unregistered lines can be registered.
4. Press PWR on the Wireless Telephone that needs to be registered. The LED
should change to mostly on once theWireless Telephone is registered.
5. Wait at least 3 seconds and then press END.
6. Return the mode switch to the NORM position.
7. To assign the extension number, hold down the FCN key until Volume Level
displays. Press the # > key (NEXT) until EXTENSION displays on the Wireless
Telephone. Press 0, then enter the correct extension number.
8. When the Wireless Telephone is turned ON , the extension will be displayed. Test
the Wireless Telephone by placing a call to each Wireless Telephone to verify
that the correct Wireless Telephone rings.