7 assign a function key to oai telephony gateway – SpectraLink 150 M3 MCU User Manual

Page 60

Advertising
background image

SpectraLink Corporation

Link WTS Installation and Operation

Part Number: 72-0075-01-C-W.doc

Page 49

13.6 Connect the OAI Telephony Gateway to the

Application Server

Using a standard 9-pin female D-type connector, connect the serial port on the front panel
of the OAI Telephony Gateway to the PC, application server, or modem that will be used
to interface with the application.

The OAI Telephony Gateway uses the following pins on the connector:

Pin

Function

2

Data OAI Receives

3

Data OAI Transmits

5

Ground

If the application is up and running, the RD and SD LEDs on the front panel of the OAI
Telephony Gateway should be lit or blinking, indicating that the OAI Telephony
Gateway is sending and receiving data to or from the PC.

13.7 Assign A Function Key to OAI Telephony Gateway

To access the OAI application, the user presses

FCN

and an assigned number key.

Follow these steps to assign a function key to inititate the OAI application.

1. Make sure a Link Wireless Telephone is registered to line 2. This is the only port

with administration access.

2. With the system up and running and within range of a Base Station, move the

Mode

switch on the MCU to the

ADMIN

position.

3. Press

START

on the Wireless Telephone registered to line 2. You should hear a

steady tone.

4. Press the

FCN

key followed by the key you want to assign for OAI access.

5. Press ##

555

, then press

END

. This assigns OAI to the specified key.

6. Return the MCU

Mode

switch to the

NORM

position.

Advertising