Siemens Gigaset SX541 WLAN dsl - Manual (Page 21)

19
First Steps
Gigaset SX541 WLAN dsl / englisch / A31008-M1025-L101-1-7619 / device.fm / 21.07.2005
Sc
hablone 2005_05_02
The back panel of the Gigaset SX541 WLAN dsl houses the sockets.
Setting up the Gigaset SX541 WLAN dsl
The Gigaset SX541 WLAN dsl can be set up in any suitable location in your home or
office. You do not need any special wiring. However, you should comply with the follow-
ing guidelines:
u Operate the Gigaset SX541 WLAN dsl only indoors within a temperature range of +5
to +40 °C. Do not position the Gigaset SX541 WLAN dsl near sources of heat. Do not
cover the ventilation slots. High temperatures can damage the device.
u A mains socket for 220/240V~ and a connection socket for the splitter or LAN must
be available where you set up the Gigaset SX541 WLAN dsl.
u Do not position the device in the immediate vicinity of stereo equipment, TV sets or
microwave ovens. This may cause interference.
u Position the Gigaset SX541 WLAN dsl so that it is as near to the centre of your wire-
less network as possible. Make sure that where you position the Gigaset SX541
WLAN dsl provides optimum reception throughout the house or office. You can
improve the reception quality by aligning the antenna (turn and/or tilt).
u Position the Gigaset SX541 WLAN dsl on a non-slip surface. The router feet do not
normally leave any traces on the surface they are on. However, some furniture sur-
faces may contain substances that attack and soften the router's rubber feet. The
feet may well mark the furniture surface in this case.
Element Description
ADSL Socket for connecting the integrated modem with the splitter’s DSL
connection.
LAN1 –
LAN4 Four 10/100 Mbps switch sockets with automatic recognition (RJ-45).
You can connect up to four Ethernet devices (such as PCs, a Hub or
Switch ).
ON/OFF Use this switch to power on or off the device.
PWR Socket for the mains adapter supplied (12V 1A DC).
Warning: Using the wrong power supply unit may damage the
Gigaset SX541 WLAN dsl.
Reset Reboot function: Press the button for longer than 1 second but less
than 5 seconds to reboot the device. This does not affect the configu-
ration settings.
Reset function: Press the button behind the small opening on the bot-
tom of the device for at least 5 seconds to return all settings to the fac-
tory settings.
Warning: This will clear all the configuration settings you have made.
Updated firmware will not be affected.
USB USB port for printer or USB bulk memory.
Phone1 / 2 Sockets for connecting analogue telephones.
Line Socket for connecting the Gigaset SX541 WLAN dsl with the splitter’s
telephone socket.