Sterling Plumbing Bypass Shower Doors SP5400 Series - Manual (Page 17)

9. Install the Door Panels
NOTE: Perform these installation steps from outside the bath/shower.
IMPORTANT! Risk of product damage and personal injury. It is critical the
bumpers prevent direct contact between the door panel and the metal frame. If the
door panel makes direct contact it will result in breakage of the glass and bodily
harm.
Install the Inside Panel
Run a rag along the each of the inside rails of the top track to remove debris.
Lift the inside door panel with the rollers facing away from you.
Position the rollers on the inside rail of the top track.
Move the inside panel to the same side the showerhead is located.
Install the Outside Panel
Lift the outside door panel with the rollers facing you and position the rollers on
the outside rail.
Position the rollers on the outside rail of the top track.
Move the outside panel to the side opposite the showerhead.
Confirm Proper Operation
Roll each door panel back and forth along the track to make sure they operate
smoothly.
Inside of Bath/Shower
Intérieur de baignoire/douche
Interior de la bañera/ducha
Inside of Bath/Shower
Intérieur de baignoire/douche
Interior de la bañera/ducha
Top Track/Rail supérieur/Carril superior
Roller/Rouleau/Rueda
Roller
Rouleau
Rueda
Inside Rail
Rail intérieur
Riel interior
Outside Rail
Rail extérieur
Riel exterior
Inside Panel
Panneau intérieur
Panel interior
Outside Panel
Panneau extérieur
Panel exterior
Bottom Track Leg
Pied de rail inférieur
Pata del carril inferior
Sterling 17 1067873-2-C