Sharp T FOUND AR-M208 - Manual (Page 83)

MISFEED REMOVAL
81
4
COP
IE
R
TROUBLE
?
2 Remove the misfed paper.
● Be careful not to tear the misfed paper during removal.
3 If the misfed paper is not seen in step 2, pull out the lower paper tray
and remove the misfed paper.
● Be careful not to tear the misfed paper during removal.
4 Close the paper tray.
5 Close the lower side cover.
● Confirm that the misfeed display has been cleared.
Misfeed in the upper exit area
If an optional job separator tray kit or an optional finisher is installed, a misfeed may occur in the upper
exit area.
1 Open the upper exit area cover.
Ar-M208_sec.book 81 ページ ２００２年６月１３日 木曜日 午後２時３７分