Samsung HMX-S15BN - Manual (Page 151)

141
Wireless Network
Message Icon Informs that... Action
Connection failed. Time
expire.
-
WPS PBC button was
not pressed within 2
minutes, or WPS PIN
was not entered to AP.
Failed to connect to
the Sender in Device to
Device mode within 2
minutes. •
•
Try again and press WPS button
or enter the WPS PIN within 2
minutes. •
Connection failed. -
Camcorder’s WLAN
configuration does not
match to that of AP. Configure the IP settings (auto
or manual) of your camcorder to
match the AP’s. •
Initializing failed. -
Failed to initialize DLNA
devices. Reset DLNA devices and try
again. •
No devices found. -
No renderer that can
be connected to the
camcorder is found in the
connected network.
Use Refresh button to search for
the renderer.
Check your network connection. •
•
No Wi-Fi AP found. -
No available AP is
found around you or the
camcorder’s WLAN is not
functioning properly.
Check whether an AP is available
near you.
If an available AP does exist and
the problem persists, contact
Samsung Service Center. •
•
File reception failed. -
Device on the other end
is turned off or network
connection has problem.
Check if recipient’s device is
turned on.
Check if network connection
works properly and try again. •
•
Invalid password. -
In Device to Device mode,
the Receiver’s and Sender’
s password do not match. Correctly enter the password
sent by Sender in Receiver
screen. •