Siemens 5890 - Manual (Page 24)

SIEMENS 5890 DSL Router
User’s Guide Chapter 3 Easy Setup
Select Protocol
SIEMENS 18
Point-to-Point Protocol over ATM (VC Multiplexing)
If you selected Point-to-Point Protocol over ATM (VC Multiplexing) from the Wan Interface page, the Point-
to-Point Protocol page is displayed when you click Next.
To configure Point-to-Point Protocol:
1. Enter PPP User Name and Password to use for authentication when establishing a WAN connection using
PPP protocol.
2. Select one or more of the following PPP Networking options:
• Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is
stopped.
3. IP Routing Enabled:
Route all IP traffic to remote hosts.
4. If you enabled IP routing, select one of the following methods for configuring IP routing:
• Obtain configuration automatically from WAN
IP routing parameters are obtained from the WAN.
• Configure IP Routing manually
IP routing parameters are set manually. If you select this options, you must provide the Source WAN IP
Address, Subnet Mask, and Default Gateway.