Sony SNC-RZ30N - Manual (Page 25)

Ad
minis
tra
ting t
he Camer
a
Setting the Camera Position and Action — Preset position setting Page
25
Network address/Subnet 1 to Network
address/Subnet 10
Type the IP addresses and subnet mask values you want
to allow or deny access to the camera.
You can specify up to 10 IP addresses and subnet mask
values. For a subnet mask, type 8 to 32.
To temporarily cancel the Default Policy for a specified
IP address/subnet mask, select Allow or Deny from the
drop-down list on the right.
Tip
The subnet mask value represents the bit number from
the left of the network address.
For example, the subnet mask value for 255.255.255.0 is
24.
If you set “192.168.0.0/24, Allow,” you can allow access
from the computers having an IP address between
192.169.0.0 and 192.168.0.255.
OK/Cancel
See “Buttons common to every setting page” on page
16.
Setting the Camera
Position and Action
— Preset position setting Page
When you click Preset position on the Administrator
menu, the Preset position setting page appears.
Use this page to store the pan, tilt and zoom positions of
the camera (Preset position) in memory and program the
sequenced action of the camera (Tour).
Storing the Pan, Tilt and Zoom
Positions
— Position preset Section
You can store up to 16 setting of the pan, tilt and zoom
positions (Preset positions) of the camera in memory.
Note
For a Preset position setting, you can store the pan, tilt
and zoom positions only. Set the Focus mode, Exposure
mode and White balance mode menu to Auto. (See
“Setting the Camera — Camera setting Page” on page
19.)
Preset No.
Select a preset number 1 to 16 from the drop-down list.
Click Preset call to move the camera to the pan, tilt and
zoom positions stored in the selected preset number.
Preset position name
Type a preset position name for the selected preset
number up to 32 characters.
Apply
Use this button to store the camera position in a preset
number.
To store, proceed as follow:
1
Display the monitor image on the main viewer
page, and pan, tilt and zoom the camera to the
position you want to store as a Preset position.
2
Select the Preset No. from the drop-down list and
enter the Preset position name.
3
Click Apply.
The camera position is stored in memory.