Saba 31-5023 - Manual (Page 17)

17
Basic setup
DOWNMIX setting
This setting will affect the audio output signal when
playing DVD discs recorded with surround multi-channel
audio. To select one of the following Downmix settings,
use the setup menu, select speaker settings to access
the DOWNMIX menu
x LT/RT: For use with an external amplifier or television
with a Dolby Pro Logic decoder.
x LO/RO: For use with a stereo amplifier/receiver or
television with conventional 2-channel
stereo.
Turn this function to ON to test each speaker individually
with a two second pink sound. The location of the
speaker will be displayed on the television screen and the
front display panel, as each speaker is being tested.
NOTE: When performing
g this test, it is common for the
Center delay setting
The center delay can be adjusted in Dolby Digital mode. To
change this setting, use the setup menu, select speaker
setup to access the following screen:
Select the desired delay time of the center speaker as
follows: OFF, 3MS, 6MS, 9MS, 12MS, 15MS.
NOTE: The default setting is 15ms. We recommend that you
change it to 9ms.
Rear delay setting
The rear delay can be adjusted in Dolby Digital mode. To
change this setting, use the setup menu, select speaker
setup to access the following screen:
Select the desired delay time of the surround speaker as
follows: OFF, 3MS, 6MS, 9MS, 12MS, 15MS.
NOTE: The default setting is 15ms. We recommend that you
change it to 9ms.
this test, it is common for the
volume of the pink noise from the subwoofer to be lower
than the volume of the pink noise from the center, front
and rear speakers.
Using the test tone mode
We recommend that you use the test tone mode after
you have set up and connected your speakers to check
the balance level and connections of each speaker.
Use the setup menu to select speaker setup, to arrive at
the following screen:
Notes:
xThe default setting is LT/RT.
xIf you are not getting any output from the speakers
connected to this system, change the setting to LO/RO.