Sony SRP-X500P - Manual (Page 13)

13
Location and Function of Parts
Input pins
Output pins
E REMOTE RS-232C connector (D-sub, 9-pin, male)
This is an RS-232C serial connector for remote control.
When a PC is connected, parameters can be set using the
SRP-X500P Manager software. The SRP-X500P can be
controlled from the external controller connected to the
REMOTE RS-232C connector.
F OUTPUT connector section
These connectors output the video signal input from the
AV/RGB INPUT video connectors.
Signal format conversion is not carried out.
COMPONENT/RGB connector (HD D-sub, 15-pin,
female): Outputs component or RGB signal.
VIDEO connector (phono jack): Outputs composite
signal.
G SPEAKERS CH terminals (1 to 4) (screw terminal)
These are the output terminals of the internal power
amplifiers.
For details on connecting the speakers, see “Speaker
connection” on page 19.
H CIRCUIT BREAKER button
The circuit breaker cuts off the main power when
excessive current flows through the AC IN connector. If
the circuit breaker trips, press the CIRCUIT BREAKER
button to reset the breaker, but do not use the SRP-X500P.
Instead, turn it off and contact the Sony dealer from whom
you purchased the unit.
I AC IN connector
Connects the supplied AC power cord.
J LINE OUTPUT connectors (1 to 4) (phono jack)
Connect to the line input connectors of a power amplifier,
CD/MD recorder, etc.
The LINE OUTPUT 3/4 connectors are factory-set to
function as the REC OUT connectors.
K AV/RGB INPUT audio connectors (A to E) (phono
jack)
Connect to the audio output connectors of the devices
whose video output is connected to the N AV/RGB
INPUT video connectors on the SRP-X500P.
When connecting a device, be sure that each output
connector on the device is connected to the AV/RGB
INPUT video and audio connector on the SRP-X500P with
the corresponding letter (A to E).
L LINE IN connectors (phono jack)
Connect to the line output connectors of a CD player, MD
recorder, etc.
M MIC INPUT connectors (1 to 4) (XLR-3-31 type)
Connect wired microphones. When wired microphones are
connected to the MIC INPUT 1/2 connectors, the input
signal from the wireless microphones take priority from
the moment the tuner units begin receiving the signal.
N AV/RGB INPUT video connectors (A to C: phono
jack, D and E: HD D-sub, 15-pin, female)
Connect to the video output connectors of the devices
whose audio output is connected to the K AV/RGB
INPUT audio connectors on the SRP-X500P.
When connecting a device, be sure that each output
connector on the device is connected to the AV/RGB
INPUT video and audio connector on the SRP-X500P with
the corresponding letter (A to E).
Connectable device Remarks
Switch -
Volume With 10 k Ω , B-curve
Emergency broadcast
system
Connected via relay
Connectable device Remarks
LED 24 V DC or less, 40 mA or less
Relay 24 V DC or less, 40 mA or less