Sharp MD-M1H - Manual (Page 18)

17
(Continued)
2,4
2,4
3
3
■ Preset tuning
You can store up to 40 stations in memory (40 sta-
tions consisting of any combination of AM and FM
stations you like) and recall them.
To enter stations into memory:
1
Perform steps 1 - 5 in the "Tuning" section.
2
Press the MEMORY button.
MEMORY MEMORY
3
Within 5 seconds, press the PRESET (
X
or
W
)
button to make the preset channel number flash
in the display.
MEMORY
● Store the stations in memory, in order, starting
with preset channel 1.
When
is displayed, a station has already been
stored in this preset number memory.
4
Within 5 seconds, press the MEMORY button
to store that station in the selected station pre-
set number memory.
MEMORY MEMORY
● If the "MEMORY" and preset number indicators
go out before the station is memorised, repeat
the operation from step 2.
5
Repeat steps 1 - 4 to set other preset stations,
or to change a preset station.
● When a new station is stored in the selected sta-
tion preset number memory, the contents previ-
ously memorised will be erased.
● To store an RDS station in memory, perform steps
2 - 4 whilst the RDS station name is being dis-
played.
1
To scan the preset stations, press the PRESET
(
X
or
W
) button for more than 0.5 seconds.
● The station preset number will flash and the pro-
grammed stations will be tuned in sequentially,
for 5 seconds each.
2
Press the PRESET (
X
or
W
) button again to
stop the memory scan at the desired station.
Note:
When the preset memory does not have any sta-
tions stored in it, the preset memory scan will not
function.
To erase all memorised stations:
When the unit is in the stand-by mode, hold and
press the TUNER and TUNING
X
buttons, and then
press the ON/STAND-BY button.
● "PRESET CLR" will appear.
To erase the memorised station:
1
Recall the memorised station to erase by press-
ing the PRESET button.
2
Press the CLEAR button.
● "MEMORY" and preset number will flash.
3
Within 5 seconds, press the MEMORY button.
4
Repeat steps 1-3 to erase other memorised sta-
tions.
To recall a memorised station:
Press the PRESET (
X
or
W
) button for less than
0.5 seconds to select the desired station.
● "MEMORY" will appear.
● The stations (preset channel number, frequency
and frequency band) which have been stored in
memory will appear in the display in numerical
order, irrespective of the frequency bands.
Backup function:
The backup function protects all station presets for
a few hours should there be a power failure or the
AC power lead is removed from the AC socket.
■ Preset memory scan
The stations saved in the preset memory can be
scanned automatically.
PRESET
(
X W
)
PRESET
(
X W
)