Sharp MD-M1H - Manual (Page 42)

41
Sleep timer setting
Timer playback
(record) setting Timer playback
(record) start
1 minute - 2 hours Desired time
Sleep operation will
automatically stop. End time
Caution:
In the following cases, the timer recording function
will not work.
● When a MiniDisc has not been inserted.
● When a playback-only MiniDisc is inserted.
● When the MiniDisc you inserted is protected
against accidental erasure.
● When there is no recording space left on the Mini-
Disc you have inserted (when the “TOC FULL
” or “DISC FULL” messages appear).
■ Sleep operation
The radio, compact disc and MiniDisc can all be
turned off automatically.
TIMER
SLEEP
/
ENTER
(Remote control operation)
1
Play the desired sound source.
2
Press the SLEEP button.
REC SLEEP SLEEP
● If you do not need to change the time, the unit
will enter the sleep mode automatically.
3
Within 5 seconds, press the ENTER button.
REC SLEEP
4
Press the or button to adjust the time.
(Maximum: 2 hours - Minimum: 1 minute)
The amount of sleep time can also be changed
during the sleep operation.
REC SLEEP
5
Press the ENTER button.
SLEEP
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
REC SLEEP
6
The unit will enter the stand-by mode automati-
cally after the preset sleep time has elapsed.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-
by mode.
The sleep operation can also be cancelled as fol-
lows if you can not set the unit to the stand-by mode
during recording.
1 Press the SLEEP button.
● “SLEEP” will flash.
2 Within 5 seconds, press the SLEEP button again.
● The sleep operation will be cancelled.
(“SLEEP” will go out.)
Notes:
● Once the sleep time is set, it will remain the same
duration until the setting is changed.
● The sleep functions of this unit cannot be used
to control equipment connected to this unit. You
must use the sleep functions of the other equip-
ment, if it has them.
■ Simultaneous sleep and timer op-
eration
To use sleep and timer playback in combi-
nation:
1 Perform steps 1 - 9 on page 39 “Timer playback”.
2 Perform steps 1 - 5 of the “Sleep operation” on
this page.
To use sleep and timer recording in com-
bination:
1
Perform steps 1 - 9 on page 40 “Timer record-
ing”.
2 Perform steps 1 - 5 of the “Sleep operation” on
this page.
(Continued)