Sony RDR-GX310 - Manual (Page 42)

42
1
Press
[TIMER].
• If the “Timer – G-Code” display appears,
press
< to switch the display to
“Standard”.
2
Select an item using
</, and adjust
using
M/m.
“Date”: Sets the date.
The item changes as follows:
Today
y Tomorrow y …… y Thu
10/28 (1 month later)
y Sun (every Sunday)
y …… y Sat (every Saturday) y
Mon-Fri (Monday to Friday)
y Mon-Sat
(Monday to Saturday)
y Sun-Sat (Sunday to
Saturday)
y Today
“Start”: Sets the start time.
“Stop”: Sets the stop time.
“CH”: Selects the channel or input source.
“Mode”: Selects the recording mode
(page 40).
• If you make a mistake, select the item and
change the setting.
3
Select “OK,” and press ENTER.
The Timer List (page 46) appears. The
TIMER REC indicator lights up on the front
panel and the recorder is ready to start
recording.
Unlike a VCR, there is no need to turn off the
recorder before the timer recording starts.
To stop recording during timer recording
Open the remote’s cover and press
x REC STOP.
Note that it may take a few seconds for the
recorder to stop recording.
Rec Mode Adjust
If there is not enough available disc space for the
recording, the recorder automatically adjusts the
recording mode to enable the entire program to be
recorded. This function is normally set to “On.”
To cancel this function, press TOOLS while the
Timer List is displayed. Select “Rec Mode
Adjust” and press ENTER. Select “Off” and press
ENTER.
If the timer settings overlap
Overlapped timer settings are shown as follows.
To store the setting as shown, select “OK.” The
program at the top of the list has priority over the
rest of the programs.
To cancel the overlapped setting, select “Cancel.”
To confirm, change, or cancel timer recording
See “Checking/Changing/Canceling Timer
Settings (Timer List)” on page 46.
To extend the recording duration time while
recording
1
Press TOOLS during recording to select
“Extend Rec Time,” and press ENTER.
2
Press
M/m to select the duration time.
You can set the duration in increments of 10
minutes, for a maximum of 60 minutes.
3
Select “OK” and press ENTER.
Timer - Standard
Set the timer manually.
Cancel
G-Code
Date
OK
Mode
Today
CH
:
Start
:
Stop
Timer
These timer settings overlap.
OK Cancel
Do you want to continue?
9:00PM-10:00PM 25ch SP 10/29
10/29 8:30PM-10:00PM 3ch SP
Wed
Wed
Extend Rec. Time
Set the timer extend function.
Wed
OK
Cancel
Extend Time
Off
9/28 10:00AM - 11:30AM 25ch SP