Sanyo PJLINK PLC-XL51 - Manual (Page 43)

43
Video Input
To store the adjusted data, select Store and press the
SELECT button. Select a level from Image 1 to 4 with
the Point ed buttons and press the SELECT button. A
confirmation box appears and then select “Yes.”
Stored data can be called up by selecting “Image” in the
Image Level Selection on pages 40-41.
Image Level Menu
Move the red frame pointer to
an image item to be set and
then press the SELECT button.
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then select
“Yes.” All adjustments return to their previous figures.
Reset
Store
Exit the Image Adjust Menu.
Quit
✔ Note:
• Noise reduction and Progressive cannot be selected
when 480p, 575p, 720p, 1035i, or 1080i is selected
(p.39).
Store
item
An interlaced video signal can be displayed in a progressive
picture. Select one of the following options.
Off………Disabled.
L1……… For an active picture.
L2……… For a still picture.
Film…… For watching a film. With this function, the projector
reproduces pictures faithful to the original film
quality.
Progressive
Noise reduction
Noise interference on the screen can be reduced. Select
one of the following options to get smoother images.
Off……… Disabled.
L1 ……… Lower reduction
L2 ……… Higher reduction
A confirmation box
appears and then
select “Yes.”
Use the Point 7 8 buttons to adjust the gamma value to get
better balance of contrast (from 0 to 15).
Gamma
Press the Point 7 button to decrease the sharpness of the
image; press the Point 8 button to increase the sharpness
of the image (from 0 to 15).
Sharpness