Speco Technologies HT-INTD3 - Manual (Page 14)

Operating your camera - INTENSIFIER Operating your camera - DNR
6) REDUCE NOISE( Dynamic Noise Reduction)
DNR reduces the video noise on the screen.
① Press the SET button to display the SETUP menu and move
the arrow to ‘REDUCE NOISE’ using the UP or DOWN button.
② SET ‘REDUCE NOISE’ to the desired mode using the LEFT
or RIGHT button.
7) INTENSIFIER
Allows you to get clear images with this function under night
or low light conditions.
①
Press the SET button to display the SETUP menu and move the
arrow indicator to ‘INTENSIFIER’ using the UP or DOWN button.
② SET ‘INTENSIFIER’ to the desired mode using the LEFT or RIGHT
button.
▶ OFF : Deactivation
▶ LOW : Low reduction of the noise
▶ AUTO : When your camera is under night or low-light
conditions select this mode. This mode allows the
camera to switch into B/W in low light conditions.
▶ MIDDLE : Middle reduction of the noise
▶ HIGH : High reduction of the noise ▶ OFF : Deactivation
● If you press “auto” button in the Intensifier mode, you can
Control the amount of intensification from 2X ~ X128.
●
Increasing the amount of Intensification results in brighter pictures
Under low light conditions, and may increase image lag.
●
Increasing the amount of intensification may cause image noise
which is to be expected as a normal condition..
Notes
● If you change the ‘GAIN’ menu from AGC-L to AGC-H, the sensitivity is
increased as well as noise on the screen.
● When the ‘GAIN’ menu is OFF, REDUCE NOISE will not work.
Notes
23 24