Speco Technologies HT-INTD3 - Manual (Page 16)

Operating your camera –
COLOR/SYNC
(2) COLOR : You can choose color and B/W mode electronically.
①
Press the SET button to display the setup menu and move the arrow
indicator to ‘COLOR’ using the UP and DOWN button.
② SET ‘COLOR’ to the desired mode using the LEFT or RIGHT button.
(3) SYNC : Two SYNCHRONIZATION modes are available INTERNAL and
EXTERNAL LINE-LOCK.
① Press the SET button to display the setup menu and move the arrow indicator
to ‘SYNC’ using the UP and DOWN button.
② SET to the desired mode using the LEFT or RIGHT button.
▶ COLOR : The camera will always display a color picture
▶ AUTO : The camera will switch into the B/W mode under
low light conditions.
● OSD Key may not work for 3 seconds when the
COLOR/BW mode is changed.
Notes
▶ INT : Internal synchronization
▶ L/L : If you choose ‘L/L’, you can adjust the desired phase.
-Press the SET button.
-You can adjust the desired phase from 0 to 270.
● When used in AC power, L/L mode can be used.
● In 12V DC, the SYNC menu defaults to ‘Internal.
Notes
27 28